Properties

The permissible short-circuit current the equipment can withstand under arcing condition

The change in phase-to-earth voltage at the terminals of the machine occurring at the start of each impulse in accordance with IEC 60034-18-42

Specify if flowline pig detection is required

Specify if piggable or not

Any performance requirements for allowing tools for pigging, through flowline requirements (TFL), workover, or other operations through the pipe, including ID, bend radius, and end-fitting transitions

Classes of pipes conforming to a combination of standard pipe outside diameters and standard pipe wall thickness with a given schedule number

Is a subtype of pipe support

A colour identification of a pipeline according to the fluid conveyed

Specify the type and grade of material that the pipeline is constructed from

A specification defined by specified circumstances in which piping components may be applied

The plant where the equipment is or will be installed

The low voltage switchgear and controlgear pollution degree of macro-environment (of installation environment) in accordance with IEC 61439

Specify when the manufacturer is to provide a connection point on each phase and earth for the attachment of a portable earthing device

Specify if a portable insulation fault locator is required for PSC-assemblies with unearthed electrical supplies (IT)

Provide a general description of the method used by the positioner to detect its location

Is a heat treatment after welding Intended to ensure that the atomic structure of a weld and heat-affected zone is restored to an optimum corrosion-resistant structure

The cosine of the angle between active power and apparent power when the motor is operated at 100% rated power

The cosine of the angle between active power and apparent power when the motor is operated at 50% rated power

The cosine of the angle between active power and apparent power when the motor is operated at 75% rated power

The cosine of the angle between active power and apparent power at the lower limit continuous operating speed at the upper torque value of the load window as per IEC 61800-4

The cosine of the angle between active power and apparent power at the upper limit continuous operating speed at the upper torque value of the load window as per IEC 61800-4

Specify if the unit has power recovery

Specify the method of cooling the power supply For example air, water etc

The total harmonic distortion in the electrical supply for which the equipment shall be rated

The PSC-assembly physical access configuration