Properties

Give a general description of the type of crane For example gantry crane, pedestal crane etc

Specify if the crankcase shall have a pressure relief device

Specifies if the design for the line requires some special attention

Pipelines where the linepipe is specified as ISO-3183 class 2 or 3

The area of a cross section

The location for the crossover flow loop to intersect the production (injection) bore

The current at minimum continuous operating speed at the upper torque value of the load window as per IEC 61800-4

The current at maximum continuous operating speed at the upper torque value of the load window in accordance with IEC 61800-4

Specify what differential protection current transformer class is required

The differential protection current transformer construction type

Specify where differential protection current transformers are to be installed

Specify if differential protection current transformer ratio is required

The method of cooling of the cylinder head of the equipment item

Specify the type of lubricator for the cylinder

Specify data for protection setting/power modelling requirements

The accepted tolerance for declared locked rotor current tolerance

The greatest steady-state root mean square current taken from the line with the motor held at rest, over all angular positions, at 100% rated voltage and frequency, as a per unit value of full load current (Is/In) including positive tolerance

The greatest steady-state root mean square current taken from the line with the motor held at rest, over all angular positions, at 80% rated voltage and frequency, as a per unit value of full load current (Is/In) including positive tolerance

The smallest measured torque the motor develops at its shaft and with the rotor locked, over all its angular positions, at 100% rated voltage and rated frequency

The smallest measured torque the motor develops at its shaft and with the rotor locked, over all its angular positions, at 80% rated voltage and rated frequency

Specify the reference unit of the product that was used to calculate its total emissions, for Example: Mass (kilogram), volume (cubic metre)

Specify the amount of declared units contained within the product, eg it's capacity

The mass per unit volume of an object or a fluid

Specify if design approval prior to fabrication is required for the proposed equipment or part of equipment

A specification according to which an item is intended to be designed