Properties

The maximum height of a functional or physical object above its base when installed

Is an inside diameter of an item that is the prime inside diameter in case the item has more than one inside diameter

Is a distance measured in the direction of the longest side of an item or in the direction of its main axis

Is a possessed aspect being a role of the substance of an artefact when used to construct the artefact from Therefore the substance should be in a solid state at the conditions at which the artefact exists

Is a subtype of stack

Is a thickness according to a design

Is a material of construction of which a lining is made

Environmental factors that require stainless steel nuts, bolts, washers and any other fixings are to be manufactured from stainless steel

Specify if stainless steel hardware is required due to environmental conditions

Specify if stainless steel plates, thickness 02 in (5 mm) minimum, under all pump feet  are required for the proposed pump

Specify when periods of standstill or storage or transport which exceed 6 months are anticipated, as described in IEC 60034-1

The beginning of the range of allowable flow in operating conditions

The beginning of the range of flow in operating conditions

The starting condition is with load, no load or partial load

An electric current that is a peak-current occurring when starting an electric energy transducer

The electric motor starting designation according to IEC 60034-12

The motor starting method for which the motor will be provided

The configuration of stator winding connection

Is an inside diameter of an item that is the prime inside diameter in case the item has more than one inside diameter

Is a distance measured in the direction of the longest side of an item or in the direction of its main axis

Is a specification which describes the applicable materials for one or more items

By which protection is provided against overpressure

The pressure at which a functional or physical object is activated

Is a thickness according to a design

Injection process where steam is injected in another material