Properties

All the properties in one place.

  • NPSH for a particular pumping system at a certain flow rate and temperature

  • Minimum NPIP required by the pump to achieve the required performance with the specified fluid at any specified point, as determined by Vendor NPIP shall always include acceleration losses

  • net tank capacity

    CFIHOS-40000239

    The volume of a tank between low liquid level and high liquid level

  • no-load loss

    CFIHOS-40000508

    The active power absorbed when rated voltage at rated frequency is applied to the terminals of one of the windings, the other windings being open-circuit

  • The product of 20 hours multiplied by the maximum constant current that a new battery can supply at 20 C (68 F) Denominated as Ah

  • nominal current

    CFIHOS-40000241

    A current which is the current a functional or physical object has been designed to operate normally

  • nominal diameter

    CFIHOS-40000509

    A diameter which is an expected (theoretical/as designed) diameter

  • nominal inlet diameter

    CFIHOS-40000242

    Is a diameter by which a quantitative diameter is referred to Typically a standardized value with defined tolerances

  • Is a diameter by which a quantitative diameter is referred to Typically a standardized value with defined tolerances

  • Is a diameter by which a quantitative diameter is referred to Typically a standardized value with defined tolerances

  • Is a diameter by which a quantitative diameter is referred to Typically a standardized value with defined tolerances

  • nominal pipe diameter

    CFIHOS-40000246

    The nominal diameter (ie not the actual diameter, but an approximate diameter as it may appear on a vendor datasheet) of the equipment at the upstream boundary of the section

  • nominal size

    CFIHOS-40000247

    Is a diameter by which a quantitative diameter is referred to Typically a standardized value with defined tolerances

  • nominal tank capacity

    CFIHOS-40000248

    The geometric volume of a tank

  • nominal wall thickness

    CFIHOS-40000249

    Specify the nominal wall thickness of the equipment at the upstream boundary of the section

  • Specify the non destructive group of methods of checking the structural quality of the functional or physical object

  • non reverse ratchet

    CFIHOS-40001374

    Specify if non reverse ratchet is required

  • Specify if the NDE bearing type to be used for ASD fed motor applications to prevent circulating common mode current is required

  • The material from which the nonwetted pressure-retaining fastener is constructed

  • NPSHA that is available for a particular pumping system at normal flow condition

  • The temperature at which a functional or physical objects cooling water is expected to operate at its inlet connection

  • The pressure at which a functional or physical objects cooling water is expected to operate

  • The differential pressure at which a functional or physical object is expected to operate normally

  • The dynamic viscosity at which a functional or physical object is expected to operate normally

  • The mass flow rate which is the extraction steam mass flow rate at which a functional or physical object is expected to operate normally