Properties

Specify where heat tracing and insulation is to be applied

Is a subtype of tracing

Specify who is responsible for supplying heat tracing

The area that is available for heat transfer

Is a number of items where each item is a tube

Specify if a heating jacket is required

Specify the heating medium

Is a specification which describes the heating tracing

A distance from the bottom to the top of something standing upright

Specify if the functional or physical object is equipped with a helper driver, to accelerate the functional or physical object into self sustaining speed and remain coupled during operation to provide supplementary shaft power

The capacitance presented to sources such as: harmonics, switching surges and transients

The hot air temperature of the heat exchanger at rated power

Specify if the functional or physical object has hot oil flushing functionality

The name of the product in liquid or gas phase

Is an allowable operating pressure that is the maximum pressure to which a container is allowed to be exposed during operating conditions when the item is new and cold

Is a temperature that is the lowest at which a significant load can be applied Typically applied to a pressure vessel Defined by the ASME Code, Section VIII, Division 1, paragraph UG-20 (see Section 3)

The pressure at which a functional or physical object is expected to operate normally

The temperature at which a functional or physical object is expected to operate normally at its inlet connection for the hot side

The mass flow rate at the hot side at which a functional or physical object is expected to operate normally

The pressure at which a functional or physical object is expected to operate normally

The temperature at which a functional or physical object is expected to operate normally at its outlet connection for the hot side

Is a number of items where each item is a tube pass

A drop in temperature that is acceptable at hot side

The medium used for testing purpose

The pressure to which a functional or physical object should be subjected to test for leakage and structural integrity