A physical object for storing energy, and which after discharge may be recharged.
An indirect contact heat exchanger that is intended to heat a liquid.
A butterfly valve that is equipped with an actuator that manipulates a stream of fluid in the response to a signal from an external sensing element and with input of energy from an external source.
An enclosure that can maintain a pressure difference.
A valve that permits fluid to flow in one direction only.
Is a shaft (civil) intended to transport flue gas to a high location in the atmosphere. It may also be used to supply fresh air via a separate flue.
A choke valve that is equipped with an actuator that manipulates a stream of fluid in the response to a signal from an external sensing element and with input of energy from an external source.
A gravity separator where two liquid substances separates and where the substance with the less gravity can be skimmed off.
A cooler that is intended to change a vapour to liquid.
A valve that can be used to modify (regulate) the fluid flow rate in a process control system. It usually includes an actuator, which responds to a signal from the controlling system and changes the position of the flow controlling element in the valve.
A cooler and an air cooled heat exchanger that is a tall structure through which air circulates by convection.
A control valve that is intended to operate at high temperature, and admit water into a deluge system.
A diaphragm valve that is equipped with an actuator that manipulates a stream of fluid in the response to a signal from an external sensing element and with input of energy from an external source.
A physical channel that acts as a conduit for fluids, gases, pipes or cables to transfer from one point to another.
A control valve that uses a rotating disc as closing element, and with a design that causes the disc to take a slightly eccentric path during actuation.
A separator intended to separate material from a solution or suspension by electrostatic charge.
A valve that is assigned to act in case of emergency.
Flexible joint between two pipes to receive expansion from the pipes.
A separator intended to remove solids from vapour or liquid.
Is a fired heat transfer equipment intended to burn fuel and to transfer the heat of combustion to a liquid without vaporising the liquid.
A physical object that is a projecting flat rim, plate, collar or rib.
A system that burns waste in an elevated flame in the open air.
A burner that burns gas emitted from a process into the atmosphere.
A flexible vertical or near vertical pipe for the flow of liquid or gas between the seabed and the surface.
A hollow cone with a tube extending from the smaller end and that is designed to catch and direct a downward flow.