An internal combustion engine that is an induction compression ignition exhaust engine which ignites a fuel air mixture.
Flexible joint between two pipes to receive expansion from the pipes.
A physical object that is intended to form material by forcing it in liquid phase through a shaping die by applying pressure and fix the form in the solid phase.
A physical object that is intended to deliver or exhaust volumes of vapour or gas at low differential pressure.
A closed transport device that is a gathering line tied into a trunk line.
Is an artefact intended to act as a barrier and boundary or means of protection or confinement.
A separator intended to remove solids from vapour or liquid.
A wall which is also a fire divider.
Is a fired heat transfer equipment intended to burn fuel and to transfer the heat of combustion to a liquid without vaporising the liquid.
A detector that is intended to sense a flame.
A specially designed switch with connections for inputs from multiple flame detectors. The switch has a built in logic to determine the presence of a flame based on these inputs.
A physical object that is a projecting flat rim, plate, collar or rib.
A system that burns waste in an elevated flame in the open air.
A burner that burns gas emitted from a process into the atmosphere.
An analysing instrument intended to determine the flash point of a substance.
A flexible vertical or near vertical pipe for the flow of liquid or gas between the seabed and the surface.
is a process unit with gentle agitation used to bring together fine particulates in wastewater into larger clumps or flocs through physical contact to enhance the subsequent separation and removal of solids in sedimentation basins.
A detecting element that is producing a signal that is proportional to a flow rate.
A gauge intended to indicate a liquid or gas flow.
A detecting instrument intended to measure and indicate flow rate and/or produce a signal which represents the measured flow rate.
An orifice plate which restrict the flow and thus develops the differential pressure that is proportional to the square of the flow rate.
A regulator that normally use the differential pressure principle across an orifice to control the valve trim and regulate flow.
A functional switch that is intended to give a signal when the flow have reached a pre-set value.
A totalizer that adds up flow measurements.
A flow transmitter providing an output signal that is proportional to the flow inputs from a flow element.